Too expensive? We have the cheaper
2535A adapter
available.
Note: This adapter can convert any 2.5" SAS/SATA/SSD drive to 3.5"
form factor. However, for 2.5" SAS drives, this adapter will change dual port to
single port. This is fine for most applications. But if your application
requires dual port, this adapter will not work for you. And, as always, a SAS
controller is required in order to support SAS drives. A 2.5" SAS drives with
this adapter installed will not work on a SATA controller although its connector
looks exactly the same as a normal SATA connector
Note: This adapter is compatible with all the 3.5" SAS/SATA drive
caddie trays from HP, Dell, IBM, or other manufacturers.
Description:
This adapter
can adapts any 2.5" form factor SAS/SATA/SSD Drive to 3.5" form factor
drive, without cables or hassles.
-
Standard position mounting holes on Adapter's bottom and sides,
equivalent to those found on a 3.5" hard drive, give you the flexibility
to mount it anywhere a 3.5" drive is used.
-
Adapter's fixed mount connectors are attached to a simple circuit board,
assuring solid connections between devices, and the outside connector is
positioned to plug into a backplane as the tray is inserted.
-
Compatible with 3Gb/s and 6Gb/s SAS/SATA/SSD drives.
- No loss
in data transfer speeds—no bridge chip used
-
Structure -- SECC(Steel Electrogalvanized Cold-rolled Coil) Steel body
Package Contents:
- 1 x
2.5" to 3.5" SAS SATA SSD HDD Adapter
- 4 x
2.5" Drive Screws
